CODERSHACK FILTERS & FITTINGS |
Filters |
Part Number: RP10266 In-Line, 20 Micron,Bullet Style |
Used in a variety of DOD inkjet printers, including Marsh�, Little David�, Willett�, and others. Used as in-line ink filter and internal printhead filter. Used as air or ink filter. | |||
Part Number: IJ-F20 In-Line, 20 Micron, Disk Style, Luer |
In line air or ink filter with luer fittings. Simple replacement using Luer fittings below. This is an ink line and/or air line filter of all polypropylene construction with a melt-blown polypropylene filter element rated at 99% retention of particles greater than 20 micron. It may be used with any type of ink, including those that are based on MEK solvent.
The filter is small in size, 25 mm barely larger than a 25 cent coin, and has quick disconnect luer lock fittings. Since luer couplings are available with various size barb fittings, the filters will fit any standard tubing. Using fittings with different size barbs on the male and female side allows a neat method of changing from one tubing size and adding filtration in one operation. Two of these filters (one inside, one outside) are used with our AJET 101 ink jet printer.
|
|||
Part Number: RP14569 Filter, FD Printhead, MEK Compatible |
Equivalent to Marsh RP29913 w/o Tubing. Suitable for air or ink systems. MEK Compatible. |
Fittings |
|
Ferruless Fittings with EPR (epdm) seals and o-rings. MEK compatible. Panel Mount for use in replacing ink cap fittings or other mounted fitting applications. Accepts tubing size .025"OD x .017ID tubing. Normally nylon tubing if MEK used. Compatible with all inks.. | ||
|
Tube Barb Fittings, Panel Mount for use in replacing cap fittings or other mounted fitting application. Accepts 1/8" ID tubing. Not recommended for Nylon tubing. Water and Alcohol applications only. Not for use with MEK inks. | ||
|
Tube Barb Termination Fittings. In line fittings used as tube termination and other inline application. Not for use with MEK inks.
|
|
Luer fittings for tubing connections - Various sizes |